If you have old drawers in kitchen cabinet drawers that are in poor condition, you can build new drawers instead of looking around to replace them. This project does not require much woodworking or carpentry experience, but you need to be familiar with some common hand tools and power. Over a weekend, you can have new drawers in your kitchen cabinet, built in your home.
Measure the internal opening kitchen cabinet drawers with a tape measure to determine the width, depth and height. Record your measurements. Measure, mark and cut with circular saw plywood 1/2 inch (1.27 cm) to be 1/2 inch (1.27 cm) smaller than the width and depth of the drawer space the cabinet.
This will be the bottom drawer. Cut four pieces of wood 1 x 3 inches (2.54 x 7.62 cm) to create the sides, front and back of the drawer. Place the plywood on a table and place the pieces just against the sides and the front and back. Ensures all parts with a nail gun to create the kitchen cabinet drawers. Lija the drawer with sandpaper intermediate grain once all the pieces are together. Apply a coat of primer with a brush and let dry for two or three hours.
Organize your cabinets can be a challenge. Sometimes, you need to store a variety of items in the cabinet and not all allow open enough. Install sliding kitchen cabinet drawers is a good solution for this problem. Although you can buy the drawers or cabinets with drawers purchase of this type, both are nothing economical solutions. Build your own kitchen cabinet drawers are the answer to have your organized pantry. Subtract 2 1/2 inches to determine the extent to cut the plywood.
Cut two sides to every drawer, 22 by 3 1/2 inches. Short the front and back depth least 2 1/2 inches. The bottom of each slide kitchen cabinet drawers should have this measure by 22 inches. Use the drill and glue on all four sides of the box, making sure every corner perfectly is straight to the drawer work properly.
Screw the rail portion on each side of the drawer, placing a 1/4 inch from the bottom edge. Cut a 1×4 pine board and 22 inches long. Cut a table 1/4 inch plywood or MDF to fit the bottom of the rail holder. Place the bracket to the cabinet, lay it to one side. Measure the space on the opposite side.